Skip to content
We independently pick everything we recommend. We earn a commission when you buy through our links, at no extra cost to you. Learn more ›
Amazon Black Friday Week deals

Multi-Process Welders

Multi-process welders that run MIG, flux core, stick and TIG from one machine. We check which torches and guns are included and which cost extra.

Multi-Process Welders ·

Is a Multi-process Welder Worth It?

A multi-process welder combines MIG, stick, and TIG in one power source; whether it is worth it depends on your projects and the limits…

Multi-process welder specs that matter

SpecWhy it matters
Process listCount what is actually included, such as MIG, flux core, stick, lift-start TIG, or plasma. Some combos advertise a process that needs a separate torch.
Gun and torch in the boxA MIG gun is often supplied while a TIG torch and a spool gun are extras. The listing should say which.
Output on each processMaximum amps often differ between MIG and stick. Look for a figure per process, not one headline number.
Dual-voltage inputRunning on both 120V and 240V lets one machine move between garage and job site, usually at reduced output on 120V.
Interface and presetsSynergic or preset controls shorten setup for beginners, while manual dials suit people who dial in settings themselves.

A multi-process machine is a compromise on purpose: one footprint, several jobs. Read each process as if it were a separate machine, and be wary of any listing that gives a single maximum amperage without naming the mode it applies to. Warranty terms also vary widely on combination units, so check whether the listing covers the whole machine or only parts of it.

Key guides